Cabinet Enclosure Coolers (Panel Coolers Air Conditioner) For Electronic Control Panels:
Cabinet Enclosure Coolers - Frigid-XTM ( Panel Coolers
)series for electronic control panels provide a low cost method of both purging and cooling electrical and electronic control panels by using a stainless steel vortex tube to create cold air from ordinary compressed air.
Cabinet Enclosure Coolers - Frigid-XTM series are compact and can be installed in minutes through a standard electrical knockout. There are virtually no moving parts.
Cabinet Enclosure Coolers (Panel Coolers
)
There are Three (4) Types to choose from:
1.
Frigid-XTM Cabinet Panel Coolers NEMA Type 12 For Electronic Control Panels for General use in industrial environments where no direct liquid spray is applied to the unit. Stainless steel construction to hold up in corrosive environments.
2.
Frigid-XTM Cabinet Panel Coolers NEMA Type 3R For Electronic Control Panels for Outdoor Use. Stainless steel to hold up to rain, snow, humidity and general outdoor use.
3.
Frigid-XTM Panel Coolers NEMA Type 4-4X For Electronic Control Panels - splash resistant, for use in wash down environments as well as outdoor use. Unique patent pending design for secure water tight protection. Stainless steel for food service and corrosive environments. Stainless steel also provides for long life in wet environments and for outdoor use.
4.
Panel Coolers - NEMA 4-4X- 316L (IP-56) For Cabinet Enclosure Cooler / Cooling- Frigid-XT series for electronic control panels provide a low cost method of both purging and cooling electrical and electronic control panels by using a stainless steel vortex tube to create cold air from ordinary compressed air.
Muffling Kits for Panel Coolers
Muffling Kits for Panel Coolers
1.
In many environments where the surroundings are very quiet or if personnel are working next to control panels, the Hot End and Cold End Muffing kits can reduce the noise levels an additional 8 dBA depending on air capacity used!!! The Hot End Muffler also acts as an excellent heat guard over the hot end, exhausting the hot air from the vortex tube cooler assembly. Noise levels with the Nex FlowT Panel Coolers can be reduced to under 64 dBA or more depending on capacity of the Panel Cooler.
Filtered, compressed air enters the cabinet enclosure coolers and through the vortex tube component. The air is split into two streams, one hot and one cold.
The muffled hot air from the vortex tube is expelled through the top of the air conditioner. The cold air is directed into the enclosure through the cold air distribution hose. Hot air inside the enclosure rises and exits to atmosphere via the air exhaust at a slight positive pressure. The cabinet enclosure coolers is both purged and cooled with clean air. No outside air enters the enclosure.
